Rod Desyne CH100-68-48-7 Guide d'installation télécharger pdf

TRAVERSING DRAPERY ROD INSTALLATION INSTRUCTION

Using bracket (B), mark screw hole

at the desired bracket height locations.

Repeat for each bracket using level if needed.

Drill pilot holes into screw marked locations.

Use 1/8” drill bit if drilling into wood

and 3/16” drill bit if drilling into dry wall.

Insert the wall anchors (F) into the dry wall and

attach bracket (B) using mounting screws (E).

If mounting to wood attach the bracket

with the screws without the wall anchors.

(B)

(E)

(F)

4 5

Attach nials onto each end of rod.

Put screw-on nial into white inserts and begin to turn until ush

and tight. .

Extend rod to desired length and slide telescopic rod

through all brackets. Turn bottom latch on center bracket inward

and tighten with screw driver. Repeat on remaining brackets.

Tighten all set screws on the top of each bracket.

Clip drapery to carriage slide clips.

(B)

Pull the two telescoping rods apart from the center until separate. Add desired amount

of carriage slides onto the track from the middle, then put rods back together.

*For three piece rod (packaged as one rod inside the other and another stand alone rod), just

add slides by sliding from the open end of rod. Connect all rods together when finished.

Untighten and turn bottom latch.

Turn top screw until ush with bracket to allow for rod installation.

Résumé du contenu

Page 1

TRAVERSING DRAPERY ROD INSTALLATION INSTRUCTIONUsing bracket (B), mark screw holeat the desired bracket height locations.Repeat for each bracket using

Commentaires sur ces manuels

Pas de commentaire

Rod Desyne CH100-68-48-7 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Rod Desyne CH100-68-48-7. Rod Desyne CH100-68-48-7 Installation Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Rod Desyne CH100-68-48-7